Used Tucsen Dhyana 400BSI V2 sCMOS Back Illuminated Monochrome Camera

Item ID: 8005254
Manufacturer: Model: Dhyana 400BSI V2 sCMOS Back Illuminated Monochrome CameraSubcategory:
Request a quote Save to Wish List


Pixel Correction, DSNU/PRNU calibration, more accurate quantitative analysis

  • To improve the overall performance of the camera, the Dhyana 400BSI V2 was calibrated in DSNU (dark signal nonuniformity) and PRNU (photo response non-uniformity) characteristically. After calibration, the DSNU value reduced from 0.3e- to 0.2e-, the PRNU value reduced from 1.6% to 0.3%. Thus the new upgraded camera has a more sophisticated capabilities, making it more suitable for quantitative analysis applications.

Top-level cooling technology to reduce the impact of noise

  • Dhyana 400BSI V2 advanced cooling mode can further reduce the impact of noise on imaging: compared to 1.2e- readout noise and 0.2e-DSNU, the dark current corresponding to 100ms is less than 0.02e-. In high-end imaging applications,dark current becomes negligible.

Wide spectral response range, high sensitivity

  • With its ultra-low noise, the advantage of the quantum efficiency in Dhyana 400BSI V2 is very significant. This is a huge breakthrough for scientific applications, not only in the visible region, but also in the ultraviolet and near-infrared.

74fps using CameraLink, 40fps using USB3.0, faster data capture

  • In addition to the signal to noise ratio advantage, the Dhyana 400BSI V2 has enhanced transmission speed, on one hand though the new CameraLink interface to meet the needs of high-end imaging research for higher frame rates, on the other hand through hardware improvements that increase the USB 3.0 throughput. These have achieved the ultimate transfer rate of 74fps with CameraLink and 40fps with USB3.0 at 4.2 MP full resolution.

Item-Specific Notes:

Tucsen Dhyana 400BSI V2 sCMOS Back Illuminated Monochrome Microscope Camera

  • Model: Dhyana 400BSI
  • Sensor size: 1.2″
  • Sensor model: Backside-illuminated Scmos
  • Color/monochrome: Monochrome
  • Quantum efficiency:
    • 60%@254nm
    • 95%@550nm
    • 50%@850nm
  • Effective no. of pixels: 2048(H) x 2040(V)
  • Pixel size: 6.5μm x 6.5μm
  • Effective area: 13.3mm × 13.3mm
  • Full well capacity: 45000e-
  • Frame rate:
    • 74fps@(4.2MP via CameraLink)
    • 40fps@(4.2MP via USB3.0)
  • Readout noise: 1.2e-(Median),1.3e- (RMS)
  • Shutter type: Rolling shutter / Global Reset
  • Exposure time: 6.6μs-10s
  • DSNU: 0.2e-
  • PRNU: 0.30%
  • Cooling method: Peltier cooling
  • Cooling temperature:
    • Forced air(Ambient at +20℃): -15 ℃
    • Water (Ambient at +20℃): -25℃
  • Dark current:
    • Forced air: 0.15 e-/p/s (-15℃)(typ.)
    • Water: 0.10 e-/p/s (-25℃)(typ.)
  • Binning: 2×2 / 4×4
  • Sub-array: Available
  • External trigger mode: Standard/Synchronous/Global trigger
  • Trigger delay function: 0-10s(1μs steps)
  • Trigger output: 3 programmable timing outputs (Exposure/Global/readout signal)
  • External trigger routing: SMA
  • Digital interface: USB3.0 / CameraLink
  • SDK: Support
  • Bit depth: 16 bit
  • Lens mount: C-mount
  • Power supply: 12V/8A
  • Power consumption: 55W
  • Camera size: 85mm x 85mm x 125mm
  • PC software: Mosaic/LabVIEW/Matlab/Micromanager/MetaMorph
  • Compatible system: Windows/Linux
  • Operating environment: Temperature: 0-40℃ Humidity: 10%-85% RH